A look at what is possible when removing rotten plywood board from the fiberglass transom/stern. there is no better way that doing it correctly. this is fiberglass boat improve construction. here. Re: marine plywood for transom i used 2 pieces of 3/4 ab exterior with 1708 in between them, it made turned out great. what size boat are you working on.. Find great deals on ebay for boat transom plywood. shop with confidence..
Outboard transoms are pretty much standardized at 1.5". most use two layers of 3/4" ply, but a stronger method is three layers of 1/2". transoms are typically reinforced with knees, usually a couple at the rail and two or three on the bilge stringers, to transmit torsion loads to the bottom.. The next step in the rebuild is the removal of the old plywood core and inside fiberglass transom skin. you will need access to the entire transom plus at least 12" up the side and bottom of the boat. depending on the boat's construction, you may be able to remove the deck cap, or you may need to make a cut through the deck and sole.. Transom replacement function of the transom. stripping rotten untreated plywood from the transom's fiberglass skin. the transom of a power boat is the strongest part of the vessel. it has to transmit the full power of the engine to the rest of the hull, as well as carry the pounding of the hull back to the engine. like the boat.
Comments
Post a Comment